Description
Spa Cover Lifter – Under-Mount (SX-L-01)
A sturdy, cabinet-free under-mount cover lifter for square and rectangular spas with a hinged cover. Adjustable centre couplers fit a wide range of spa sizes — no drilling into your spa cabinet required.
Key Features
- Under-mount design — no screws into the cabinet
- Fits square/rectangular spas up to 2440 mm
- For hinged covers only — maximum 2 sections
- Requires 300 mm rear clearance & 130 mm side clearance
- 2 mm aluminium alloy tubing — strong & rust-resistant
- Easy to assemble and install
What’s in the Box
- 2 × Mounting Brackets
- 3 × Centre Couplers (1 long, 2 short)
- 2 × Support Arms
- 2 × Upper & Lower Support Arms
- 4 × Bushings
- Fasteners: Hex bolts, flat washers, large screws (16 pcs)
- 18 × Small Black Dome Caps
- 2 × Screw Connectors
- 18 × Self-tapping Screws
- 4 × Big Caps
Installation Overview
- Attach Support Arm and Bushings to each Mounting Bracket using supplied bolts, washers, screws, and connectors. Slide brackets under each side of the spa.
- Insert the upper & lower support arms into a centre coupler, then into the bracket support arms. Fit dome caps over screw heads.
- Lay the lifter on the spa cover, fasten with self-tapping screws, fold the cover, slide into support arms, and push down to stow.
Safety Note: If installed with an under-mount bracket or on a conductive surface (e.g., concrete), the cover lifter must be earth-bonded by a licensed electrician.
Compatibility: Suits hinged covers only; not suitable for individual section (non-hinged) covers.
Tip: Measure your spa’s outer width to choose the best centre coupler combination (long/short) for a snug fit.