Hurricane Jet Body Only - for Hurricane 125mm Jets - Spa Industries, Signature, Leisurite, Designer, Cyclone and more

Hurricane Jet Body Only - for Hurricane 125mm Jets - Spa Industries, Signature, Leisurite, Designer, Cyclone and more

Hurricane Jet Body Only - for Hurricane 125mm Jets. Has 19mm / 3/4" large barb, and a 10mm 3/8" small barb. Requires 96mm Hole. Used on Spa Industries, Signature, Cyclone, Designer, Leisurite, Wilton, and more. Comes with body, seal, locking nut, and ring.

• Physically Stocked, unlike most "drop-shipping" websites.
• Shipped from VIC, NSW, WA, QLD

We also have complete repair kits for these jet bodies here.

Spa Jet Install Notes:

Remove old jet body

• Remove old jet body.
• Remove old silicone/gasket residue and clean + dry both sides of the shell (no oils/soap film) before refitting.
• You may need to be creative in removing old jet body.

Sealing

• Apply silicone sealant on the jet face and rear where it passes through the shell.
• Many techs remove any supplied gaskets and rely on silicone + correct nut tension (our preference).
• Tighten the nut evenly until sealed. Use some silicone sealant on the thread to lock it in place. Do not overtighten (can crack/distort the shell or fittings).
• Note there are no specific tools for this job, so be creative!

Hose / Plumbing

• PVC glue on male barbs only. Do not put PVC glue into the tube/hose (can create a glue plug).
• Use gentle heat (or hot water) to soften the hose so it slides onto barbs easier.

Wait at least several hours before testing.

AJETHUBOBL