Balboa M7 1.5kW Spa Heater Element / Tube - Suits GL EL GS VS and others - 55614

Obsolete - Replace with 2.0kW version here after confirming your spa can handle an extra 2.5A.

Genuine 1.5kW Balboa Instruments & Balboa Water Group heater assembly for all GS, VS, EL, GS, BP, Dominator series (and many others) spa controllers. Note, this is a genuine part, and not an inferior generic part. See below for list of part numbers this supersedes. Part no: 55614. Note, this is not the more common 3.0kW heater. As of late 2023, comes with the new easier-to-install Plug n Click system.

• Genuine Balboa product - now with 'Plug n Click' as of 2023. We note others are passing others off as "Genuine." We are an authorised Balboa dealer.

Important - Please Read:

• As of 2023 new M7 Balboa heaters come with an attached Balboa Plug n Click lead. Older spa controllers that still have the copper heater connections will need the Balboa Plug n Click Adaptor (see Add-Ons). The Plug n Click adaptor replaces the old copper connections for an easier-to-fit heater replacement.
  
• We have noted some online sellers are removing the Plug n Click leads. Failure to use the Plug n Click system will result in a rejection of warranty from Balboa. 
• Length: 381mm or 15"
• Diameter: 57mm or 2.25" (referred to as 2")
• Product supplied may vary slightly from pictures.
  
• Damage to heater studs is not covered by warranty.

Suits all Twin-Sensor M7 Balboa Systems without pressure switch. 

Notes:

• 2 x sensor mounts - suits twin sensor M7 systems. Also suits Dominator, BP, GS, GL, BFBP, ES, GS series and many others. See list below.
• Comes with heater tube, heater element, and twin sensors
• Make sure when loosening and tightening element nuts, that the base stud nut is held firmly, with no movement. If the base stud nut is twisted, it damages the epoxy seal and element, and cannot be covered by warranty.
• Base stud nuts use with 3/8", or 1/4" slimline spanners. (not metric)
• Product supplied may vary slightly from picture.